Silicones, Inc.Silicones, Inc.RTV-2 Silicone Rubber
All products

Technical Datasheet · P-268

P-268 Silicone Rubber

Platinum cure (addition)

Key properties

Shore A hardness (7 day)68Shore A

Feels like a tire tread. Firm, with little give.

Mixed viscosity70,000–95,000cps

Log scale. Lower viscosity pours thinner and captures finer detail; higher viscosity holds on vertical surfaces.

Working time1.0–2.0hours
Cure time16–24hours
Tear resistance60ppi

General Information

P-268 is a two component addition cure silicone rubber mold making material. It has a high durometer, high modulus, superb physical properties, minimal shrinkage and extreme chemical resistance making it an excellent choice for prototyping, casting urethane foam and other plastics. P-268 cures at room temperature in 16 - 24 hours; however, the curing rate can be accelerated with Pt Accelerator at room temperature, or with heat.

The information contained in this data sheet is, to our best knowledge, true and accurate, but all recommendations or suggestions are made without guarantee. Since the conditions of use are beyond our control, Silicones, Inc. disclaims any liability incurred in connection with the use of our products and information contained herein.

Typical Properties

Uncatalyzed Compound

Color
Base:TanActivator:Blue
Viscosity
Base:150,000–190,000cpsActivator:100–500cps
Mixing Ratio
By weight:n.a.By volume:n.a.
Mixed Viscosity
70,000–95,000cps
Working Time
1.0–2.0hours
Cure Time
16–24hours
Shelf Life
6months

Vulcanized (Cured) Properties

Measured at 7 days, 70°F / 50% relative humidity

Shore A Hardness
One day:687 days:68
±4 durometer
Tear Resistance
60 ± 15ppiASTM D624
Tensile Strength
800 ± 50psiASTM D412
Elongation
175%ASTM D412
Service Temperature
-60 to 600°F
Shrinkage
0.00%
Specific Gravity
1.25
Coverage
n.a.
100 % Modulus
700 + 50

Take this datasheet with you

Print it, or save it as a PDF.

Planning a job? Confirm fit with our team first. Contact us.